Wood Plastic Composite (WPC) Fencing Guide

• Wood Plastic Composite (WPC)
• Resistant to Mold, Mildew, Rotting, & Termites
• 100% Waterproof, Non-Toxic, Anti-Slip, Anti-Scratch & Fire Resistant!
• Easy to Install!
• Enhances your outdoor space
• No painting or staining is required

*** Disclaimer - Please read all instructions before installing your new floor.
***2 Types of Post Holders (Not Included in kit)

We sell two types of post holders. The first type has a Squared Bottom and attaches to the surface.

The second type has a Pronged Bottom that penetrates the ground and is anchored by wet cement. Be sure the cement cures/dries completely after first ensuring the post is completely vertical (90° to the ground)

***Please read all instructions before installing your new fence.

***Below the Surface Installation

1. 1. Pronged Lawn Post - Dig a hole where you would like to begin building your fence. Wet concrete can be used to seal the post holder into the hole. Please let cure for 48 hours or until completely dry.

1. 2. Insert the post inside the post holder. Be sure that it is completely vertical and straight.

1. 3. Once everything is lined up properly, fit the bottom cover to the post.

1. 4. Insert your boards horizontally from the top to the bottom.

1. 5. Insert the side bar, fitting the top cover to the post, and fasten with a corner clip

1. 6. Finally, fasten the post cap on top.

***Above the Surface Installation

1. 1. Squared Bottom Post - Dig a hole where you would like to begin building your fence. Then, fill in the hole with cement and let cure for 48 hours or until completely dry.

1. 2. Drill the Square Bottom Post into the existing concrete with four expansion screws. Insert the post inside the post holder. Be sure that it is completely vertical and straight.

1. 3. Once everything is lined up properly, fit the bottom cover to the post.

1. 4. Insert your boards horizontally from the top to the bottom.

1. 5. Insert the side bar, fitting the top cover to the post, and fasten with a corner clip.

1. 6. Finally, fasten the post cap on top.